NEW 16″ x 40″ Two Roll Mill, Item # 1729
New Machinery, New Rubber Mills, Rubber & Silicone 2-Roll Mills, Rubber & Silicone Mills: 2-Roll
NEW 16″ x 40″ Two Roll Mill, Item # 1729
- Model # GMI-16X40
- Cored rolls for heating or cooling
- Rolls: 16″ Ø x 40″ Long (400X1000mm)
- Roller bearings
- Motorized roll nip adjustments
- Friction ratio = 1.27:1
- Two teflon stock guides mounted on heavy construction round bar providing full adjustability along the bar and the length of the rolls.
- Triple reduction (50:1) gear reducer with helical gearing. Catalog rating 175 HP @ 1200 RPM.
- Direct drive
- Bearing housings with anti-dust seals and with zirc fittings for manual grease lubrication. Automatic grease lubrication system available separately upon request.
- Hydraulically operated safety brake
- Overhead perimeter cable, front & rear belly bars, front kick plate, and front & rear E-stop pushbuttons for operator safety.
- Low -speed and high-speed couplings
- Two rotary joints with siphon pipes for roll cooling
- Stainless steel mill pan
- 60HP/480V/1200RPM motor
- Unitized steel base for easy installation
- Operator control station with start, stop, emergency stop, left & right roller nip adjustment, etc.
- Main electrical panel with voltmeter, ammeter, SOFT motor starter, fuses, power disconnect, control transformer, cooling fan, etc.
- 480V/3PH/60HZ
- Overall Dimensions: 15’ L x 5’3” W x 5’10” H (18,000 Lbs)
- Height from ground to top of rolls: 46” without leveling feet or anti-vibration pads (offered separately). Minimum height required by OSHA is 50″.
